Suggestions & Feedback

Subject / Started by	Replies / Views	Last post
Material Protection Started by SD_Gabe	2 Replies 72834 Views	June 05, 2009, 12:23:16 PM by SD_Gabe
Failure TAB V7.0.53 Started by Stressed	1 Replies 102893 Views	November 11, 2014, 06:47:41 PM by James
User Interface Started by Stressed	1 Replies 104552 Views	February 15, 2017, 02:59:11 PM by James
Laminate Form - Show % 0, %45 and %90 plies in the form Started by Stressed	2 Replies 70478 Views	July 24, 2009, 11:17:29 AM by Rocketman007
Laminate Allowables- Margins of Safety are quoted outside the design envelope Started by Stressed	3 Replies 75125 Views	June 25, 2009, 10:34:04 AM by jjainswo
Crippling Test Prediction - Fixed or Free Edges Started by Stressed	0 Replies 61180 Views	June 25, 2009, 10:18:30 AM by Stressed
Hypersizer Edge Load Feature (Sum forces and moments) Started by Stressed	0 Replies 61374 Views	July 30, 2009, 08:17:26 AM by Stressed
Exporting Material Properties from Hypersizer to a Nastran Bulk Data Deck Started by Stressed	0 Replies 61241 Views	July 30, 2009, 08:36:19 AM by Stressed
LAMINA allowables and Correction Factors Started by Stressed	1 Replies 95617 Views	October 01, 2010, 12:10:32 PM by Phil
Wing Analysis - Buckling of a Spar Web Started by Stressed	0 Replies 62064 Views	July 30, 2009, 10:10:53 AM by Stressed
Material Properties Report - Options not available to export LAMINATE properties Started by Stressed	0 Replies 59610 Views	July 30, 2009, 01:38:12 PM by Stressed
Buckling - Panels with holes (Orthotropic and Isotropic Materials) Started by Stressed	0 Replies 60386 Views	July 31, 2009, 09:43:47 AM by Stressed
Importing F06 files and bulk data Started by Stressed	1 Replies 97739 Views	March 23, 2011, 11:55:09 AM by JY
Combining Thermal and Mechanical Load Conditions Started by Stressed	0 Replies 60462 Views	September 14, 2010, 05:42:20 PM by Stressed
Combining Load Conditions (Mechanical) Started by Stressed	0 Replies 61598 Views	September 14, 2010, 05:44:44 PM by Stressed
SLIM VISION Started by Stressed	1 Replies 95211 Views	March 23, 2011, 11:51:03 AM by JY
Analysis Template - Options to turn on / off analysis methods Started by Stressed	0 Replies 60226 Views	September 14, 2010, 06:27:49 PM by Stressed
Lowest MS toggle in Failure TAB Started by Stressed	0 Replies 61007 Views	September 14, 2010, 06:31:42 PM by Stressed
Free Edge Delamination Started by Stressed	0 Replies 64092 Views	September 15, 2010, 10:22:30 AM by Stressed
Tee and Hat pull off analysis Started by Stressed	0 Replies 81276 Views	September 15, 2010, 10:29:09 AM by Stressed