Copying Component Data To Display Sets

In the Sizing form, navigate to the component of interest.
In the Dimensions tab, click Copy | Copy this tab data to all components in specified display set(s) using the [concept].

The display set pick dialog appears.
Select the display sets you wish to apply the settings to.
Click OK.
The settings from the current component have now been pushed to all components with the same concept. Note that for the dimensions tab, most of these settings are linking group data (min-max bounds, variable materials, etc.).

In the Sizing form, navigate to the component of interest.
Right-click on any field and select Apply value to all components in specified Display Sets(s).

An example using the "X Span" field of the Buckling tab is shown below.

The display set pick form appears.
Select the display sets you wish to apply the settings to.
Click OK.
The setting from the current component has now been pushed to all components. Typically, these settings are applied only to components within the same component type. For example, the X Span of a smeared panel will not be applied to smeared beams or stringer segments.

In the Sizing form, browse to the component of interest.
In the Failure tab, click Options and select Apply selections to all components in specified Display Sets(s).

The display set pick form appears.
Select the display sets you wish to apply the settings to.
Click OK.
The visible analysis selections from the current component have now been pushed to all relevant components. These settings are applied only to components within the same component type. For example, analysis selections from a smeared panel will not be applied to stringer segments. See Failure Tab.