News: HyperSizer.com has a Community Board and Customer Support System. Submit a ticket at http://hypersizer.com/ticket

Author Topic: Laminate Optimization Based on Max Laminate Strain  (Read 25687 times)

dana.frye

  • Client
  • **
  • Posts: 11
    •  
Laminate Optimization Based on Max Laminate Strain
« on: June 23, 2023, 04:31:21 AM »
I am looking to optimize a laminate within a non-fea project, based on a single criteria. I wish the peak strain in the global laminate X direction to be less than a specified value. How can I go about doing this? I tried to add a value to the strain X field of the properties tab within the sizing form, but it does not appear to impact the sizing in any way. I cannot seem to get the "strain limit" failure analyses on the failure tab to impact the sizing either. Any advice?

James

  • Administrator
  • *****
  • Posts: 286
    •  
Re: Laminate Optimization Based on Max Laminate Strain
« Reply #1 on: June 23, 2023, 08:00:20 AM »
What about using the laminate strain allowables?

dana.frye

  • Client
  • **
  • Posts: 11
    •  
Re: Laminate Optimization Based on Max Laminate Strain
« Reply #2 on: June 23, 2023, 01:14:06 PM »
Can you elaborate on how to go about doing that? Do you mean modifying the material laminate allowables in the material (Strain: Compression Open Hole for example) to the target strain, then toggling on composite strength, laminate, compression, open hole failure analyses for example?
« Last Edit: June 23, 2023, 01:28:40 PM by dana.frye »

James

  • Administrator
  • *****
  • Posts: 286
    •  
Re: Laminate Optimization Based on Max Laminate Strain
« Reply #3 on: June 26, 2023, 07:44:31 AM »
Exactly. Use the laminate strain analysis method to implement a strain cut-off.
There's an example within the HME document.

http://www.hypersizer.com/download.php?type=analysis&file=AID221-231_Material_Strength,_Composite,_Laminate-Based.HME.pdf

-James