News: HyperSizer.com has a Community Board and Customer Support System. Submit a ticket at http://hypersizer.com/ticket

Author Topic: Analysis Details...  (Read 262 times)

sorinb

  • Client
  • **
  • Posts: 1
    •  
Analysis Details...
« on: November 13, 2018, 01:33:36 PM »
Hi,

I am trying to verify a negative margin of safety for a solid laminate composite. When I right click on the check that shows the negative margin and to the "Analysis Details..." option, the excel files does show the margin, the allowable, and a strain (I'm checking an OHC). The strain and the allowable, however, cannot reproduce the margin.
I could reproduce the margin using the running loads and a strain calculator, and using the bottom ply strain.
Is there a way to show both top and bottom plies strains in the Analysis Details spreadsheet in order to verify the margin of safety?

Thank you,
Sorin

Stephen

  • Administrator
  • *****
  • Posts: 24
    •  
Re: Analysis Details...
« Reply #1 on: November 13, 2018, 01:48:25 PM »
Hi Sorin,

This is a known reporting issue which was recently fixed. I am reaching out via email to follow up.

Thanks,
Stephen