News: Contact us to upgrade your software!

Author Topic: "Controlling Analysis Loads" in FBD tab  (Read 6878 times)

hunterqiu

  • Client
  • **
  • Posts: 20
    •  
"Controlling Analysis Loads" in FBD tab
« on: June 16, 2009, 02:59:26 AM »
An uniaxial stiffened panel is only loaded by Nx with B.C. "Simple", but the design-to load Mx is gotten in "Controlling Analysis Loads".
From my understanding, loaded by uniaxial load with simple B.C., there is no Mx reaction.  Is it correct, my parameters' setting?

jjainswo

  • Guest
Re: "Controlling Analysis Loads" in FBD tab
« Reply #1 on: June 16, 2009, 07:45:35 AM »
This is correct.  HyperSizer is computing the virtual loads in 3 places at the two adjacent edges and the center of the panel.  You are correct assuming there will be no Mx at the edge in a simply supported uniaxial panel but there will be a virtual Mx in the center since the simple BC on the edges is constraining longitudinal displacement.