Analyzing & Optimizing Composite Layups

Subject / Started by	Replies / Views	Last post
how to resize a single component by passing from DL to EL ? Started by eugenio	1 Replies 97067 Views	November 23, 2015, 08:42:02 AM by Brent
[Addition-Question for Sublaminates]Looking for solution of type mismatch error Started by cmcho	0 Replies 96799 Views	April 27, 2020, 01:21:22 AM by cmcho
Correction factor for composite laminates on honeycomb core Started by HyperSizer User	4 Replies 92048 Views	June 25, 2009, 11:29:58 AM by Rocketman007
HyperSizer picks the candidate design with MAXIMUM weight. Started by iankim	3 Replies 89434 Views	September 10, 2008, 10:24:05 PM by Phil
Discrete Laminates from Effective Laminates Help. Started by JEA	3 Replies 89315 Views	September 14, 2009, 07:45:08 AM by JEA
PCOMP Non Structural Mass Started by garyjh	1 Replies 83753 Views	October 11, 2010, 10:16:08 AM by Phil
Discretization of Ply Drop Offs Started by hyperuser	1 Replies 80419 Views	April 26, 2010, 01:26:16 PM by James
How can I do the optimization with layup definition? Started by iankim	1 Replies 76538 Views	September 15, 2008, 10:26:45 AM by Phil
Designing with one-stack unstiffened and sandwich concepts Started by HyperSizer User	1 Replies 74138 Views	November 05, 2008, 04:15:38 PM by Phil
Stiffened Panel Optimization - Error Message: User Defined Analysis Undefined Started by MKLEE	1 Replies 73285 Views	October 22, 2008, 08:14:20 AM by Phil
Hard to understand the popup warning.(f06 element number) Started by iankim	1 Replies 71709 Views	October 23, 2008, 06:59:47 AM by Phil
How to switch load case Started by iankim	1 Replies 71568 Views	October 30, 2008, 10:31:25 AM by Phil
MOVED: How do I design skins and spars with uniaxial stiffeners at once? Started by Phil	0 Replies 67949 Views	November 12, 2008, 11:21:17 AM by Phil
MOVED: Optimizing for both stiffener and frame spacing Started by Phil	0 Replies 67046 Views	November 12, 2008, 11:20:30 AM by Phil