Analyzing & Optimizing Composite Layups

Subject / Started by	Replies / Views	Last post
Error Message - Set Variables for component/Assembly, number of laminates Started by martinjb	0 Replies 101576 Views	June 12, 2017, 10:41:18 AM by martinjb
# Requested Designs ignored Started by cra5072	2 Replies 104857 Views	July 22, 2011, 05:49:48 PM by cra5072
Load Set Factors vs Component Load Factors Started by dana.frye	1 Replies 108724 Views	December 04, 2020, 08:41:08 AM by Stephen
Honeycomb Core Taper Analysis Started by Mike T.	3 Replies 114375 Views	July 01, 2014, 03:50:12 PM by James
Buckling margin not coinciding with FE analysis result. Started by iankim	3 Replies 115841 Views	December 21, 2012, 08:40:55 AM by Ryan
Inconsistency in Load Case Results Started by Mike T.	4 Replies 117481 Views	August 08, 2014, 08:15:23 AM by Ryan
Linking layups for PORT/STBD components in linking groups Started by ChrisSummers	3 Replies 117734 Views	October 08, 2019, 11:30:38 AM by Brent
Hard to understand HyperSizer calculation in sandwich optimization Started by iankim	9 Replies 119586 Views	December 16, 2008, 09:01:23 AM by Phil
Sequecing issue Started by ChrisSummers	3 Replies 123280 Views	October 18, 2019, 03:39:23 AM by ChrisSummers
Regarding wind turbine blade (cutting components) Started by orchidworld	3 Replies 123683 Views	June 13, 2020, 03:42:45 AM by dana.frye
Laminate Optimization Based on Max Laminate Strain Started by dana.frye	3 Replies 126168 Views	June 26, 2023, 07:44:31 AM by James
+/-30* plies Started by eric	5 Replies 129730 Views	March 20, 2015, 09:25:45 AM by James
Aganin about link top/bottom facesheets of sandwich concept. Started by cmcho	4 Replies 144920 Views	July 22, 2021, 07:14:10 PM by cmcho
Issue generating Discrete Laminates for Composite panels Started by z__4yn	0 Replies 168609 Views	October 03, 2023, 07:05:28 AM by z__4yn