Analyzing & Optimizing Composite Layups

Subject / Started by	Replies / Views	Last post
Issue generating Discrete Laminates for Composite panels Started by z__4yn	0 Replies 19648 Views	October 03, 2023, 07:05:28 AM by z__4yn
Laminate Optimization Based on Max Laminate Strain Started by dana.frye	3 Replies 18543 Views	June 26, 2023, 07:44:31 AM by James
Linking layups for PORT/STBD components in linking groups Started by ChrisSummers	3 Replies 26679 Views	October 08, 2019, 11:30:38 AM by Brent
Load Set Factors vs Component Load Factors Started by dana.frye	1 Replies 28305 Views	December 04, 2020, 08:41:08 AM by Stephen
MOVED: How do I design skins and spars with uniaxial stiffeners at once? Started by Phil	0 Replies 17978 Views	November 12, 2008, 11:21:17 AM by Phil
MOVED: Optimizing for both stiffener and frame spacing Started by Phil	0 Replies 16880 Views	November 12, 2008, 11:20:30 AM by Phil
Optimizing laminates with linking groups Started by Tom Dragone	1 Replies 26225 Views	July 19, 2014, 10:22:29 AM by James
PCOMP Non Structural Mass Started by garyjh	1 Replies 27961 Views	October 11, 2010, 10:16:08 AM by Phil
rectangular beam-discrete laminates-cross sectional linking options issue Started by eugenio	0 Replies 10043 Views	September 20, 2023, 01:17:37 AM by eugenio
Regarding wind turbine blade (cutting components) Started by orchidworld	3 Replies 32799 Views	June 13, 2020, 03:42:45 AM by dana.frye
Sequecing issue Started by ChrisSummers	3 Replies 32226 Views	October 18, 2019, 03:39:23 AM by ChrisSummers
Stiffened Panel Optimization - Error Message: User Defined Analysis Undefined Started by MKLEE	1 Replies 17690 Views	October 22, 2008, 08:14:20 AM by Phil
Way to Define Composite Ply Angle Tolerance? Started by khender	1 Replies 27079 Views	October 24, 2016, 09:43:42 AM by James
[Addition-Question for Sublaminates]Looking for solution of type mismatch error Started by cmcho	0 Replies 23720 Views	April 27, 2020, 01:21:22 AM by cmcho