COMPOSITE ANALYSIS AND
STRUCTURAL SIZING SOFTWARE
Login
or
Register
HOME
Search Section:
Everything
Forum Only
Help Only
Website Only
Match:
Any search words
All search words
Advanced Search
Username
Password
Always stay logged in
Forgot your password?
Not a member?
Register Now
News:
HyperSizer.com has a Community Board and Customer Support System. Submit a ticket at
http://hypersizer.com/ticket
Home
Help
Search
Login
Register
HyperSizer Support Forum
»
Software Use
»
FEM Coupling (HyperFEA)
»
Importing temperatures from Ansys
« previous
next »
Print
Pages: [
1
]
Go Down
Author
Topic: Importing temperatures from Ansys (Read 32171 times)
Heini
Posts: 2
Importing temperatures from Ansys
«
on:
September 28, 2017, 04:24:12 AM »
Is it possible to import temperatures from Ansys? The temperatures are applied as nodal body force loads (APDL: BF) in a static analysis in Ansys.
Logged
James
Administrator
Posts: 286
Re: Importing temperatures from Ansys
«
Reply #1 on:
September 28, 2017, 07:42:07 AM »
For ANSYS thermal loads are not supported.
See:
https://hypersizer.com/help_7.3/#FE-Results-Import/results-thermal_loads.php%3FTocPath%3DFeatures%7CFEM%2520Interface%7CFEA%2520Loads%7C_____6
For other solvers, HyperSizer supports element forces.
You could assign reference temperatures to the load sets in HyperSizer. This will define the temperature at which the material properties are extracted for margin assessment.
I hope this is helpful.
-James
Logged
Print
Pages: [
1
]
Go Up
« previous
next »
HyperSizer Support Forum
»
Software Use
»
FEM Coupling (HyperFEA)
»
Importing temperatures from Ansys