News: Contact us to upgrade your software!

Author Topic: Believe Install was unsuccessful  (Read 4809 times)


  • Client
  • **
  • Posts: 1
Believe Install was unsuccessful
« on: September 04, 2012, 03:18:08 PM »
I recently proceeded to install HyperSizer. I am able to run the hat-stiffened panel buckling tutorial, however when I attempt to size the AP1 following the tutorial, any analysis I attempt to perform returns an error like this:

There was an error running HyperSizer.

... Group = 1  Component= 33    Component 1 of 62    Combination 1 of 144

The .hdg document that opens up gives no additional information.
I am wondering if I should attempt to reinstall the application or change some configuration.

Thank you for any info.


  • Administrator
  • *****
  • Posts: 250
Re: Believe Install was unsuccessful
« Reply #1 on: September 05, 2012, 12:10:03 PM »
Can you confirm you have full read/write access to your project working directory?

You can also check to see if the Project Setup Form is pointed to the correct .bdf and .f06 files. You should have full read/write access to the FEA directory as well.