News: HyperSizer.com has a Community Board and Customer Support System. Submit a ticket at http://hypersizer.com/ticket

Author Topic: Candidate Designs  (Read 13778 times)

GrEp_Analyst

  • Client
  • **
  • Posts: 6
    •  
Candidate Designs
« on: August 18, 2010, 02:40:00 PM »
I am having a problem increasing my candidate designs.

Page 33 of this document

http://www.hypersizer.com/hypersizer_version_5.6.38_new_features_and_enhancements.pdf

says that I should be able to increase my designs to about 2.5million. However, when I change the settings in the back door data, it still doesn't allow more than 100k.

Is this feature functioning in 5.8.11?

Thanks

Phil

  • Administrator
  • *****
  • Posts: 218
    • HyperSizer Structural Sizing Software
    •  
Re: Candidate Designs
« Reply #1 on: September 09, 2010, 02:10:10 PM »
Hi Bryan,

This capability is functional in version 5.8.11 if you installed HyperSizer to the default folder:

C:\Program Files\HyperSizer

If you chose a different location, then it doesn't work.

This limitation has been fixed and will be available in Version 5.9.

Phil

phoenixxp

  • *
  • Posts: 6
    •  
Re: Candidate Designs
« Reply #2 on: July 18, 2012, 08:38:05 AM »
Dear Phil,

I am using Hypersizer version 6.2.46.
When I try to optimize the angle-grid stiffened panel family I get the same issue even after modifying the backdoor data of the project.
It tells me that unless I modify the parameters for >100000 designs the program will not be able to calculate anything.
Are you familiar with this issue in the mentioned version?

Thanks,

Leonid

James

  • Administrator
  • *****
  • Posts: 286
    •  
Re: Candidate Designs
« Reply #3 on: July 26, 2012, 12:57:46 PM »
I have not been able to repeat this error. I've tried modifying the limit number of candidate designs for the project and as a default value. It seems to be working for all Grid Stiffened panels. Remember, the project value only modifies the current project.

Try modifying the "default" value.