HyperSizer Support Forum
Software Use => Scripting => Topic started by: Ruben on October 25, 2019, 07:40:59 AM
-
Hi,
Is there any way to determine if an orthogrid concept is a two-sided machining set in the Cross-sectional linking from the COM interface?
Regards,
Ruben
-
Hi Ruben,
Unfortunately the two-sided machining set is not exposed via the scripting API. This capability can potentially be added in the next software release. We'll keep you posted.
Thanks,
Brent
-
I check if the resulting B11 is 0, and if so, know that the machining is double sided.