HyperSizer Support Forum

Project Applications => Project Applications => Topic started by: hunterqiu on July 28, 2009, 01:08:56 AM

Title: joint in Graphic of v5.6.38
Post by: hunterqiu on July 28, 2009, 01:08:56 AM

in Graphic of v5.6.38, from tool bar "joint", joint between components can be created, but

there is no setup form or tab interface to make this analysis, for example, the doubler's material

selection, run tab, result display, etc.

Title: Re: joint in Graphic of v5.6.38
Post by: Phil on July 29, 2009, 02:08:19 PM

I apologize for the confusion, but the Joints feature through the graphics has not been officially released yet.  It was accidentally exposed through the 5.6.38 update, but in Version 5.7.8, it is no longer available.