HyperSizer Support Forum

Software Use => HyperSizer Stress Reports => Topic started by: Stressed on June 18, 2009, 10:35:32 AM

Title: Stress Report - Laminate Analysis (Open Hole)
Post by: Stressed on June 18, 2009, 10:35:32 AM
If the user requests only a laminate analysis the stress report does not show the lay-up in section 3 of the stress report. If both lamina and laminate analysis is requested the lay-up is defined. A short term work around.

Also, the laminate allowable properties should be quoted for reference in the allowables section of the stress report.