HyperSizer Support Forum

Engineering & Analysis Methods => Miscellaneous Analysis & Methods => Topic started by: khender on September 01, 2016, 02:47:16 PM

Title: Core Ribbon Direction vs. Material Direction
Post by: khender on September 01, 2016, 02:47:16 PM

Is it possible to specify a core ribbon direction that is NOT in the material x direction?  As far as I can tell, HyperSizer always places it in the material x direction and there is no opportunity for the user to change it, either by picking the y direction or a different coordinate system entirely.  Is this correct?

Thank you.