HyperSizer Support Forum

Suggestions & Feedback => Suggestions & Feedback => Topic started by: Rocketman007 on July 31, 2009, 10:32:17 AM

Title: FWT analysis - Honeycomb Panels
Post by: Rocketman007 on July 31, 2009, 10:32:17 AM

Hypersizer Rev 5.7.x allows the user to conduct a FWT analysis. This failure mode is listed in the Failure TAB and the user inputs the bond panel adhesive configuration in the sizing form OPTIONS tab.

These FWT options should only be available for a bond panel, but Hypersizer shows the FWT analysis option for a ONE STACK concept. Consider removing the FWT options for a one stack concept for user clarity.