HyperSizer Support Forum

Software Installation => Software Installation => Topic started by: backflip_boy on September 04, 2012, 03:18:08 PM

Title: Believe Install was unsuccessful
Post by: backflip_boy on September 04, 2012, 03:18:08 PM
I recently proceeded to install HyperSizer. I am able to run the hat-stiffened panel buckling tutorial, however when I attempt to size the AP1 following the tutorial, any analysis I attempt to perform returns an error like this:

There was an error running HyperSizer.


... Group = 1  Component= 33    Component 1 of 62    Combination 1 of 144


The .hdg document that opens up gives no additional information.
I am wondering if I should attempt to reinstall the application or change some configuration.

Thank you for any info.
Title: Re: Believe Install was unsuccessful
Post by: James on September 05, 2012, 12:10:03 PM
Can you confirm you have full read/write access to your project working directory?
See:http://hypersizer.com/help/index.php#Form-DbX/form-hs_options.php

You can also check to see if the Project Setup Form is pointed to the correct .bdf and .f06 files. You should have full read/write access to the FEA directory as well.

-James