HyperSizer Support Forum
Software Use => Analyzing & Optimizing Stiffened Panels => Topic started by: tomhandford on October 25, 2019, 04:10:06 AM
-
When analyzing frame stiffened panels I get the following error message for some components:
Error analyzing component XXXXX load case XXXXX. [PlasticCorrection.f90] Plastic Buckling Correction: ga and gb same sign.
When the error occurs analysis of the entire assembly is stopped. Is there a way to identify and isolate the failure mode this error is occuring for? Is there a way to complete analysis for the other components in the assembly rather than stopping the analysis process?
-
You can turn off the plastic buckling correction factors in the backdoor data options.
See: http://hypersizer.com/help_7.3/#BackdoorData/bd-11-buckling_coefficients.php
Last two options.
-James
-
Hi James,
Can you provide some more information on the calculation of these factors ga and gb, I can't find any reference to them in the methods documents.
Thanks
Tom