HyperSizer Support Forum
Software Use => Miscellaneous Software Topics => Topic started by: GrEp_Analyst on August 18, 2010, 02:40:00 PM
-
I am having a problem increasing my candidate designs.
Page 33 of this document
http://www.hypersizer.com/hypersizer_version_5.6.38_new_features_and_enhancements.pdf
says that I should be able to increase my designs to about 2.5million. However, when I change the settings in the back door data, it still doesn't allow more than 100k.
Is this feature functioning in 5.8.11?
Thanks
-
Hi Bryan,
This capability is functional in version 5.8.11 if you installed HyperSizer to the default folder:
C:\Program Files\HyperSizer
If you chose a different location, then it doesn't work.
This limitation has been fixed and will be available in Version 5.9.
Phil
-
Dear Phil,
I am using Hypersizer version 6.2.46.
When I try to optimize the angle-grid stiffened panel family I get the same issue even after modifying the backdoor data of the project.
It tells me that unless I modify the parameters for >100000 designs the program will not be able to calculate anything.
Are you familiar with this issue in the mentioned version?
Thanks,
Leonid
-
I have not been able to repeat this error. I've tried modifying the limit number of candidate designs for the project and as a default value. It seems to be working for all Grid Stiffened panels. Remember, the project value only modifies the current project.
Try modifying the "default" value.