HyperSizer Support Forum

Software Use => FEM Coupling (HyperFEA) => Topic started by: rpreuhs on November 10, 2013, 06:22:27 PM

Title: How do you display results say Minimum Margin of Safety for An Assembly
Post by: rpreuhs on November 10, 2013, 06:22:27 PM
I turned on the switch for Element Based results.  I created an assembly.  I ran analysis for the entire assembly.  When I go to "Data" "Element or Panel results" it won't plot for the entire assembly.  It just plots for the "active" component.  Not sure what to do here.
Title: Re: How do you display results say Minimum Margin of Safety for An Assembly
Post by: James on December 16, 2013, 06:17:55 PM
The FEA load processing method is a component setting. When you change the FEA statistical loading method for the component, you need to right-click and apply to all components in the assembly.

See: http://hypersizer.com/help/#Form-Sizing/HowTo/right_click_apply.php

-James