HyperSizer Support Forum

Engineering & Analysis Methods => Material Strength Composites: Ply Approach => Topic started by: Karthik on July 23, 2020, 07:09:01 PM

Title: Tsai-Hill margin based on ply mid-plane strain
Post by: Karthik on July 23, 2020, 07:09:01 PM
Hello,

When calculating ply by ply margins using Tsai-Hill theory, it seems like Hypersizer computes strain for every ply at top, mid and bottom locations and reports the minimum margin of the three. I realized this is the reason I was not able to match the margins with what is calculated by Nx Nastran which only calculates strain at mid-plane of each ply. Is there an option to force Hypersizer to consider only mid-plane strain for margin calculation and report just that in sizing form?
Title: Re: Tsai-Hill margin based on ply mid-plane strain
Post by: James on July 24, 2020, 08:12:54 AM
Not in the native failure criteria.

We could write a quick analysis plugin do evaluate ply-based strength criteria with mid-plane ply stress & strain. That would be a super-simple plugin.

-James
Title: Re: Tsai-Hill margin based on ply mid-plane strain
Post by: Karthik on July 24, 2020, 01:10:26 PM
Thanks James. That plug in would be really useful. Should I put a formal request for this?