HyperSizer Support Forum

Software Use => Scripting => Topic started by: cfriedland5 on March 11, 2014, 02:35:41 PM

Title: Adding Failure Analyses
Post by: cfriedland5 on March 11, 2014, 02:35:41 PM

Is it possible to add failure analyses to a component using the COM? I would like to apply a failure check to only certain components in an automated fashion.

Title: Re: Adding Failure Analyses
Post by: Ryan on March 11, 2014, 04:05:06 PM

No, unfortunately this capability is not exposed. If this is for overall project setup, the current best practice in V7 is to use the "Apply to.." display sets/ assemblies feature to help manage component specific failure analysis selections.

-Ryan