HyperSizer Support Forum

Software Use => Miscellaneous Software Topics => Topic started by: sorinb on November 13, 2018, 01:33:36 PM

Title: Analysis Details...
Post by: sorinb on November 13, 2018, 01:33:36 PM
Hi,

I am trying to verify a negative margin of safety for a solid laminate composite. When I right click on the check that shows the negative margin and to the "Analysis Details..." option, the excel files does show the margin, the allowable, and a strain (I'm checking an OHC). The strain and the allowable, however, cannot reproduce the margin.
I could reproduce the margin using the running loads and a strain calculator, and using the bottom ply strain.
Is there a way to show both top and bottom plies strains in the Analysis Details spreadsheet in order to verify the margin of safety?

Thank you,
Sorin
Title: Re: Analysis Details...
Post by: Stephen on November 13, 2018, 01:48:25 PM
Hi Sorin,

This is a known reporting issue which was recently fixed. I am reaching out via email to follow up.

Thanks,
Stephen