News: HyperSizer.com has a Community Board and Customer Support System. Submit a ticket at http://hypersizer.com/ticket
« previous next »
Pages: [1]   Go Down

Author Topic: Determining if orthogrid is double sided  (Read 29942 times)

Ruben

  • *
  • Posts: 40
    •  
Determining if orthogrid is double sided
« on: October 25, 2019, 07:40:59 AM »
Hi,

Is there any way to determine if an orthogrid concept is a two-sided machining set in the Cross-sectional linking from the COM interface?

Regards,
Ruben
Logged

Brent

  • Administrator
  • *****
  • Posts: 26
    •  
Re: Determining if orthogrid is double sided
« Reply #1 on: October 25, 2019, 04:41:38 PM »
Hi Ruben,

Unfortunately the two-sided machining set is not exposed via the scripting API. This capability can potentially be added in the next software release. We'll keep you posted.

Thanks,

Brent
Logged

Ruben

  • *
  • Posts: 40
    •  
Re: Determining if orthogrid is double sided
« Reply #2 on: November 12, 2019, 05:44:20 AM »
I check if the resulting B11 is 0, and if so, know that the machining is double sided.
Logged
Pages: [1]   Go Up
« previous next »