Miscellaneous Software Topics

Subject / Started by	Replies / Views	Last post
Importing FEM: PCOMPs With Honeycomb Core Started by TonyH	3 Replies 71478 Views	July 01, 2014, 03:53:16 PM by James
Error while importing Forces - MSC Nastran Started by larass	9 Replies 97872 Views	June 25, 2014, 06:18:50 AM by Ryan
Thermal Set Started by ULBsha	14 Replies 126283 Views	April 04, 2014, 03:04:33 PM by James
Error Message: Graphics window > Data > HyperSizer Strains, Hypersizer Stresses Started by djgarrett21	1 Replies 65086 Views	December 16, 2013, 06:15:49 PM by James
HyperSizer 6.4 FEM Update Started by Ruben	2 Replies 66219 Views	September 25, 2013, 09:41:19 AM by Ruben
Selection of Failure Analysis Category Started by ULBsha	2 Replies 66146 Views	September 05, 2013, 10:10:01 PM by ULBsha
Color Palettes - Output Laminate Ply Started by MGerhardt	1 Replies 63769 Views	June 18, 2013, 08:21:51 AM by James
Rod/Bulb Stiffened Panel Family Started by bob_o	2 Replies 69498 Views	June 10, 2013, 03:49:57 PM by bob_o
Circular Beam Family Started by scott.ford	1 Replies 65097 Views	May 17, 2013, 05:13:48 PM by James
Free Edge Support Condition Started by bob_o	0 Replies 62232 Views	April 17, 2013, 09:58:07 AM by bob_o
1-D beam/rod element with composite material Started by ksi8518	3 Replies 76215 Views	October 09, 2012, 09:15:04 AM by James
Candidate Designs Started by GrEp_Analyst	3 Replies 72270 Views	July 26, 2012, 12:57:46 PM by James
Number of component limit? Started by ksi8518	1 Replies 64751 Views	June 12, 2012, 05:36:53 PM by James
C-beam and I-Beam modelling Started by ksi8518	2 Replies 71063 Views	June 06, 2012, 06:42:54 PM by ksi8518
invalid Coordinate system cosine vectors. Started by ksi8518	1 Replies 63862 Views	May 25, 2012, 09:46:34 AM by Ryan
Beam Section Must have width 0 error Started by ksi8518	3 Replies 74567 Views	May 24, 2012, 06:25:59 PM by Ryan
Updating from HyperSizer 6.1.69 to newer 6.1 versions Started by Phil	0 Replies 61345 Views	August 26, 2011, 11:43:32 AM by Phil
Does HyperSizer recognize scientific notation formats in bulk data file? Started by hyperuser	1 Replies 64561 Views	June 23, 2011, 09:25:21 AM by James
Line #122, Error #3316, Layups must be numbered 10000 through 19999 Started by SD_Gabe	5 Replies 81440 Views	April 14, 2011, 08:04:24 AM by James
Graphics Window 'Save Snapshot...' error message Started by garyjh	2 Replies 69590 Views	March 29, 2011, 04:15:36 AM by garyjh