COMPOSITE ANALYSIS AND
STRUCTURAL SIZING SOFTWARE
Login
or
Register
HOME
Search Section:
Everything
Forum Only
Help Only
Website Only
Match:
Any search words
All search words
Advanced Search
Username
Password
Always stay logged in
Forgot your password?
Not a member?
Register Now
News:
Contact us to upgrade your software!
Home
Help
Search
Login
Register
HyperSizer Support Forum
»
Software Use
»
Analyzing & Optimizing Stiffened Panels
»
Error analyzing component - Plastic Buckling Correction: ga and gb same sign
« previous
next »
Print
Pages: [
1
]
Go Down
Author
Topic: Error analyzing component - Plastic Buckling Correction: ga and gb same sign (Read 25382 times)
tomhandford
Client
Posts: 3
Error analyzing component - Plastic Buckling Correction: ga and gb same sign
«
on:
October 25, 2019, 04:10:06 AM »
When analyzing frame stiffened panels I get the following error message for some components:
Error analyzing component XXXXX load case XXXXX. [PlasticCorrection.f90] Plastic Buckling Correction: ga and gb same sign.
When the error occurs analysis of the entire assembly is stopped. Is there a way to identify and isolate the failure mode this error is occuring for? Is there a way to complete analysis for the other components in the assembly rather than stopping the analysis process?
Logged
James
Administrator
Posts: 286
Re: Error analyzing component - Plastic Buckling Correction: ga and gb same sign
«
Reply #1 on:
October 25, 2019, 07:11:53 AM »
You can turn off the plastic buckling correction factors in the backdoor data options.
See:
http://hypersizer.com/help_7.3/#BackdoorData/bd-11-buckling_coefficients.php
Last two options.
-James
Logged
tomhandford
Client
Posts: 3
Re: Error analyzing component - Plastic Buckling Correction: ga and gb same sign
«
Reply #2 on:
October 25, 2019, 07:23:28 AM »
Hi James,
Can you provide some more information on the calculation of these factors ga and gb, I can't find any reference to them in the methods documents.
Thanks
Tom
Logged
Print
Pages: [
1
]
Go Up
« previous
next »
HyperSizer Support Forum
»
Software Use
»
Analyzing & Optimizing Stiffened Panels
»
Error analyzing component - Plastic Buckling Correction: ga and gb same sign