News: HyperSizer.com has a Community Board and Customer Support System. Submit a ticket at http://hypersizer.com/ticket

Author Topic: Open Hole Compression/Tension Strain Analysis Method  (Read 40658 times)

HyperSizer User

  • Client
  • **
  • Posts: 47
    •  
Open Hole Compression/Tension Strain Analysis Method
« on: August 05, 2008, 09:55:20 AM »
We are using the open hole compression allowable in HyperSizer to act as a fatigue check.   We created a new property and entered a failure strain in the open hole allowable property. When we run fatigue analysis we choose the open hole compression analysis option.
 
Does Hypersizer simply looks at the uniaxial case for the element or does it include the shear term in calculating the Margin of Safety. To do this we would have to use an interaction equation not specified in Hypersizer. We assumed Hypersizer simply calculates a uniaxial MS. Thanks.

Phil

  • Administrator
  • *****
  • Posts: 218
    • HyperSizer Structural Sizing Software
    •  
Re: Open Hole Compression/Tension Strain Analysis Method
« Reply #1 on: August 05, 2008, 10:11:21 AM »
Both the Open Hole Compression (OHC) and Open Hole Tension (OHT) ply based analyses are longitudinal max strain failure methods.  For each ply, HyperSizer calculates the strain in the 1 direction (the fiber direction) and then compares the strain to the allowable to calculate the margin.  If the strain is positive, it compares to the OHT allowable, if negative, it compares to the OHC allowable. 

While this is not an interaction equation at the ply level, if you enter a shear load for the laminate, that shear will have an effect on the 1 direction strain of any off axis plies, therefore laminate shear strain will have an effect on this margin.

You should be able to confirm this behavior.  Set the OHT allowable equal to the etu1 strain allowable on the Strain Allowables I tab.  Also set the OHC allowable equal to the ecu1 allowable.  On the failure tab, turn on all of the max strain composite strength margins along with the Open Hole Tension and Open Hole Compression margins.  No matter what you put in for a load on the composite, the Max Strain 1 direction margin should match either the OHC or the OHT margin (depending on whether the load is compressive or tensile).
« Last Edit: August 05, 2008, 10:21:13 AM by Phil »