Software Use > Analyzing & Optimizing Stiffened Panels

Orthogrid Stiffener Height to Thickness Ratio

(1/1)

Gawain:
Is there a way to set the maximum stiffener height to stiffener thickness ratio?  I've gone through the backdoor data and in 'Geometry Checks', I've changed Rule 4 which I think should do this but doesn't seems to work.  Is this the correct setting to change and if so, should it work for a Orthogrid panel concept or is there an alternative way of doing this?

Brent:
Hi Gawain,

Make sure the "Geometry Check Rule 4" failure mode is activated in the sizing form, failure criteria tab for the applicable components. It should be contained in the geometry check category.

-Brent

Hillens:
What happens if the Geometry Check Rule 4 failure mode isn't active, Brent?

Navigation

[0] Message Index