Software Use > Miscellaneous Software Topics

Non-FEA Panel - multiple pressure only loadcases

(1/1)

MattA:
Hi,

I have created a panel (metallic orthogrid) as a non-FEA project and set fixed geometry.  I applied a +0.01 pressure as LC101 and a -0.01 pressure as LC102.  There are no other loads, only pressure.  All margins came back as being LC101.  I then set LC101 pressure to 0, and it returned no margins.  However, when I set LC101 to -0.01 it returned lower margins than the +ve pressure case.  My conclusion from this is that it is only running the first loadcase.

I have checked that all loadcases are activated.  I am using 7.3.37

Any thoughts?

MattA:
As a further investigation, if I run the 2 loadcases and put a very small running load for Nx, Hypersizer then runs both loadcases and I get margins against multiple loadcases.  Is this a bug?

Stephen:
Hi Matt,

It looks like this is indeed a bug. It seems that HyperSizer is not running the second loadcase because it thinks there are no loads applied; it is apparently not checking the pressure field. I've submitted a report to our developers to investigate and fix, but I think you've found the best work-around in the meantime (applying a very small Nx). Sorry for the inconvenience, we will work to fix this in an upcoming release.

-Stephen

MattA:
Super, thanks for confirming and reporting it Stephen.

eric:
Deja-vu...this same thing caught me too a while back.  Putting a dummy load in there also worked for me.  Hopefully can be fixed in the next iteration!

Navigation

[0] Message Index