COMPOSITE ANALYSIS AND
STRUCTURAL SIZING SOFTWARE
Login
or
Register
HOME
Search Section:
Everything
Forum Only
Help Only
Website Only
Match:
Any search words
All search words
Advanced Search
Username
Password
Always stay logged in
Forgot your password?
Not a member?
Register Now
News:
HyperSizer.com has a Community Board and Customer Support System. Submit a ticket at
http://hypersizer.com/ticket
Home
Help
Search
Login
Register
HyperSizer Support Forum
»
Software Use
»
Analyzing & Optimizing Stiffened Panels
»
Stiffened Panel Analysis - Repair Checks (Stiffener)
« previous
next »
Print
Pages: [
1
]
Go Down
Author
Topic: Stiffened Panel Analysis - Repair Checks (Stiffener) (Read 23391 times)
stressed2
Posts: 2
Stiffened Panel Analysis - Repair Checks (Stiffener)
«
on:
May 05, 2014, 01:16:49 PM »
Geometry Checks (Stiffener Repair Options)
The document AID067-074 and the Hypersizer help would be more helpful with clarifications. The documentation implies repair rules 71 to 75 are only applicable for composite stiffened panels. Is this correct ?
Also, it would be useful to explain the rational for the back door default geometry check values where possible. The defaults values should state if they are applicable for metallic or composite structures.
Logged
James
Administrator
Posts: 286
Re: Stiffened Panel Analysis - Repair Checks (Stiffener)
«
Reply #1 on:
May 06, 2014, 05:37:01 PM »
The HME document states that Geometry rules 71a-71e are only available for composite stiffened panels. The others, 72-75 can be used for both metallic and composite stiffened panels. The default ratios were tuned for composite stiffened panels.
Logged
designerBridge2009
Posts: 1
Re: Stiffened Panel Analysis - Repair Checks (Stiffener)
«
Reply #2 on:
December 24, 2016, 05:41:33 PM »
Hi
Can anyone help me on elementary stages on hyper sizer?
How can I build PM1 file at first, I just have dat and f06 files of a SSSS Isogrid Squar plate from NASTRAN and There is not any PM1 file! Without this file, Analyz Does not work!
Logged
James
Administrator
Posts: 286
Re: Stiffened Panel Analysis - Repair Checks (Stiffener)
«
Reply #3 on:
December 27, 2016, 10:04:39 AM »
HyperSizer does not require a PM1 file. To import a FEM you need a Nastran input file (.dat) and the output file (.op2/.f06).
I recommend to watch the following video tutorial.
https://www.youtube.com/watch?v=3OiP2WlTmp0
-James
Logged
Print
Pages: [
1
]
Go Up
« previous
next »
HyperSizer Support Forum
»
Software Use
»
Analyzing & Optimizing Stiffened Panels
»
Stiffened Panel Analysis - Repair Checks (Stiffener)