News: HyperSizer.com has a Community Board and Customer Support System. Submit a ticket at http://hypersizer.com/ticket

Author Topic: Use element peak compression for buckling  (Read 11642 times)

eric

  • Client
  • **
  • Posts: 12
    •  
Use element peak compression for buckling
« on: October 08, 2014, 09:54:15 AM »
How do I configure my project to use the element peak compression*factors as the design to loading for component buckling?  I would like to see what happens when using the compressive loading of the worst element over a component instead of the average of negative element results.

Thanks!
Eric

James

  • Administrator
  • *****
  • Posts: 286
    •  
Re: Use element peak compression for buckling
« Reply #1 on: October 08, 2014, 11:21:55 AM »
Currently there is no automated way to use peak element loads for panel buckling in HyperSizer v7.0. The panel buckling analysis always uses average compression Nx, Ny and Nxy.

You could look at the Critical load cases section in the stress report and extract the peak element loads for each component, then push them back in as user loads to size each component for buckling. For any component in an FEA project, you can switch from FEA loads over to user loads on the Free Body tab.

-James