News: HyperSizer.com has a Community Board and Customer Support System. Submit a ticket at http://hypersizer.com/ticket
« previous next »
Pages: [1]   Go Down

Author Topic: Adding Failure Analyses  (Read 16369 times)

cfriedland5

  • Client
  • **
  • Posts: 18
    •  
Adding Failure Analyses
« on: March 11, 2014, 02:35:41 PM »
Is it possible to add failure analyses to a component using the COM? I would like to apply a failure check to only certain components in an automated fashion.
Logged

Ryan

  • Administrator
  • *****
  • Posts: 145
    •  
Re: Adding Failure Analyses
« Reply #1 on: March 11, 2014, 04:05:06 PM »
No, unfortunately this capability is not exposed. If this is for overall project setup, the current best practice in V7 is to use the "Apply to.." display sets/ assemblies feature to help manage component specific failure analysis selections.

-Ryan
Logged
Pages: [1]   Go Up
« previous next »