Compatibility with Ansys 14.5

[Sebastian]

Hi,

we switched form Ansys Mechanical 14.0 to 14.5. Ansys changed serveral output values from double precision to single precision. So the *.rst file is changed.

Since this version switch the loads read by hypersizer are zero or very large(1e30). Have you tested HS with Ansys 14.5? If this is a problem with the new Ansys version, when will be a HS version available that works with Ansys?

If required I can also provied test files for this issue.

best regards
S. Freund

[Ryan]

Version 6.4.56 has been updated with support for ANSYS 14.5. You can use the link below to request the update.

http://hypersizer.com/corporate/contact-us.php?subject=Request%20Software%20Download

-Ryan