News: HyperSizer.com has a Community Board and Customer Support System. Submit a ticket at http://hypersizer.com/ticket

Author Topic: Natural Frequency  (Read 26284 times)

hyperuser

  • Client
  • **
  • Posts: 7
    •  
Natural Frequency
« on: September 28, 2009, 05:15:38 PM »
What specific methodolgoy does Hypersizer use to determine the natural frequency?

I modeled a plate and evaluated both simple and clamped boundary conditions.  I noticed that Hypersizer calculated an identical natural frequency for the two models.  Does Hypersizer not account for the increased stiffness of the clamped model?  Is the frequency being reported for the simple or clamped boundary condition?

Phil

  • Administrator
  • *****
  • Posts: 218
    • HyperSizer Structural Sizing Software
    •  
Re: Natural Frequency
« Reply #1 on: September 30, 2009, 11:05:29 AM »
The method we use is currently only applicable to simple-simple boundary conditions, therefore changing the BCs on the buckling tab will not affect the natural frequency results. The boundary conditions specified on this tab are applicable to panel buckling only.

The method we use is a standard plate based modal analysis with simple-simple BCs. Unfortunately we have no formal documentation for this method yet.

The method we are using is based on the following:

Whitney, J., Structural Analysis of Laminate Anisotropic Plates, Technomic Publishing Company, 1987.

The method is described in Section 7.7 (pp. 197-203)

Formal documentation of this method should be coming sometime soon.


« Last Edit: September 30, 2009, 01:00:50 PM by Phil »