News: HyperSizer.com has a Community Board and Customer Support System. Submit a ticket at http://hypersizer.com/ticket

Author Topic: hyperFEA launch button  (Read 13514 times)

hunterqiu

  • Client
  • **
  • Posts: 20
    •  
hyperFEA launch button
« on: July 29, 2009, 04:38:16 AM »

in v5.6.38, hyperFEA can be launched in hypersizer interface, but in v5.7.8, can not be.

is this function cancelled in v5.7.8?

by the way, the function "joint" in Graphic in v5.7.8 can not be found, is it cancelled ?

Phil

  • Administrator
  • *****
  • Posts: 218
    • HyperSizer Structural Sizing Software
    •  
Re: hyperFEA launch button
« Reply #1 on: July 29, 2009, 02:15:27 PM »
HyperFEA should be available in 5.7.8.  Is the button greyed out or is it active, but when you push it nothing happens?

HyperFEA will not work for workspaces.  You must be in a project with FEA.  Could this be the problem?

If it is still not working, look in the folder C:\Program Files\HyperSizer\HyperFEA.  You should see a file there called HyperFEA.exe.  Does this file exist?


The joint functino in the graphics has not been officially released for version 5.7.  It was exposed in 5.6.38 by mistake.  We will make an announcement when this functionality is officially ready to go.


hunterqiu

  • Client
  • **
  • Posts: 20
    •  
Re: hyperFEA launch button
« Reply #2 on: July 29, 2009, 08:48:04 PM »

thanks, phil.

the hyperFEA works well now.  the function is in setup form (I only seeked for it in sizing form)