Project Applications > Project Applications

joint in Graphic of v5.6.38

(1/1)

hunterqiu:

in Graphic of v5.6.38, from tool bar "joint", joint between components can be created, but

there is no setup form or tab interface to make this analysis, for example, the doubler's material

selection, run tab, result display, etc.

Phil:
I apologize for the confusion, but the Joints feature through the graphics has not been officially released yet.  It was accidentally exposed through the 5.6.38 update, but in Version 5.7.8, it is no longer available.

Navigation

[0] Message Index