News: Need training? HyperSizer Training Videos are available now! Learn more here: https://hypersizer.com/trainingevents/e-learning/

Author Topic: joint in Graphic of v5.6.38  (Read 31419 times)

hunterqiu

  • Client
  • **
  • Posts: 20
    •  
joint in Graphic of v5.6.38
« on: July 28, 2009, 01:08:56 AM »

in Graphic of v5.6.38, from tool bar "joint", joint between components can be created, but

there is no setup form or tab interface to make this analysis, for example, the doubler's material

selection, run tab, result display, etc.

Phil

  • Administrator
  • *****
  • Posts: 218
    • HyperSizer Structural Sizing Software
    •  
Re: joint in Graphic of v5.6.38
« Reply #1 on: July 29, 2009, 02:08:19 PM »
I apologize for the confusion, but the Joints feature through the graphics has not been officially released yet.  It was accidentally exposed through the 5.6.38 update, but in Version 5.7.8, it is no longer available.