Engineering & Analysis Methods > Bolted Joints
Characteristic Distance Do (Tension and Compression)
(1/1)
Stressed:
The value of characteristic distance (Do) for tension and compression is not the same value. Can HyperSizer accommodate a both tension and compression values for Do.
Rocketman007:
Hypersizer Version 5.7.6 is programmed to include one value of Do, and is applicable for both tension and compression.
A work around is to determine the critical loading condition and modify Do as appropriate.
A future HyperSizer revision could include the capability of both tension and compression values of Do and may also include a value of Do dependent on the percentage of 45 deg or 0 deg plies. These Do values would also be component based.
Navigation
[0] Message Index
Go to full version