News: Contact us to upgrade your software!

Author Topic: Yspan length for curved panel  (Read 26915 times)

hunterqiu

  • Client
  • **
  • Posts: 20
    •  
Yspan length for curved panel
« on: June 16, 2009, 04:08:12 AM »
in Buckling tab, it is shown the max transverse buckling length is one half of circumference (?·R) for a curved panel

but in user manual Pro, page 119, it is mentioned "the transverse buckling length will be limited to ¼ the distance around a
cylindrical body".

So which one is correct?

jjainswo

  • Guest
Re: Yspan length for curved panel
« Reply #1 on: June 16, 2009, 08:42:24 AM »
The transverse buckling span will determine the buckling wave length.  Since the buckling waves will be symmetric, using either 1/2 the circumference or 1/4 of the circumference should yield close to the same buckling margins of safety for a curved panel.  HyperSizer will compute the buckling margins of safety for any transverse buckling length, but it is suggested not to enter a buckling length larger than 1/2 the circumference due to its drastic change in buckling margin of safety.