Miscellaneous Software Topics

Subject / Started by	Replies / Views	Last post
Analysis time increased with 7.3.37 installation Started by martinjb	7 Replies 33304 Views	October 28, 2020, 01:53:14 PM by James
Non-FEA Panel - multiple pressure only loadcases Started by MattA	4 Replies 14852 Views	July 15, 2018, 07:28:33 PM by eric
Can't Apply Limit and Ultimate Factors to Thermal Load Sets Started by MatthewZiglar	1 Replies 23047 Views	March 15, 2021, 12:27:57 PM by aeromaner
Color Palettes - Output Laminate Ply Started by MGerhardt	1 Replies 11797 Views	June 18, 2013, 08:21:51 AM by James
Recursive Load Error Started by mnoftz	3 Replies 25207 Views	May 01, 2019, 09:16:11 AM by Stephen
Parallel Processing Started by mnoftz	1 Replies 12065 Views	April 22, 2019, 08:23:52 AM by Brent
Nx from Stresses tab does not match Nx in Analysis Details report Started by Msegade	1 Replies 25383 Views	March 17, 2021, 07:46:31 AM by James
Meaning of T- and C- in FEA loads tab? Started by Msegade	2 Replies 23684 Views	March 17, 2021, 05:49:54 AM by Msegade
Change the material direction in the Hypersizer Graphics window?? Started by orchidworld	0 Replies 11041 Views	August 17, 2014, 10:53:52 PM by orchidworld
Regarding "Link facesheet top and bottom stack materials" Started by orchidworld	3 Replies 13885 Views	August 27, 2014, 08:26:50 PM by James
Confusion regarding "T" Beam Started by orchidworld	2 Replies 12411 Views	August 18, 2014, 01:31:53 AM by orchidworld
if the FEA load(elment load) can be exported the excel same time in future? Started by orchidworld	2 Replies 12025 Views	August 13, 2014, 03:01:22 AM by orchidworld
buckling span directions are error Started by orchidworld	3 Replies 12520 Views	August 13, 2014, 03:02:35 AM by orchidworld
HOW TO DEAL WTIH about two direction pressure (Beam) Started by orchidworld	1 Replies 11574 Views	August 06, 2014, 07:46:57 AM by James
there is an error when the V6.4 was replaced V6.1.80 in the same computer. Started by orchidworld	1 Replies 14016 Views	November 30, 2015, 09:49:16 AM by James
hypersizer vs isight Started by orchidworld	1 Replies 13251 Views	July 21, 2015, 02:39:24 PM by Ryan
Stiffness Requirements File in General FEA Constraints Started by oyama	1 Replies 31742 Views	July 08, 2021, 07:35:51 AM by BStier
intergroup optimization Started by Paul Wagner	0 Replies 13498 Views	April 16, 2010, 10:57:02 AM by Paul Wagner
margins of safety question Started by Paul Wagner	0 Replies 11927 Views	October 29, 2009, 06:11:14 PM by Paul Wagner
Updating from HyperSizer 6.1.69 to newer 6.1 versions Started by Phil	0 Replies 12973 Views	August 26, 2011, 11:43:32 AM by Phil