Analyzing & Optimizing Composite Layups

Subject / Started by	Replies / Views	Last post
# Requested Designs ignored Started by cra5072	2 Replies 31375 Views	July 22, 2011, 05:49:48 PM by cra5072
Regarding wind turbine blade (cutting components) Started by orchidworld	3 Replies 32141 Views	June 13, 2020, 03:42:45 AM by dana.frye
HyperSizer picks the candidate design with MAXIMUM weight. Started by iankim	3 Replies 20365 Views	September 10, 2008, 10:24:05 PM by Phil
Laminate Optimization Based on Max Laminate Strain Started by dana.frye	3 Replies 17648 Views	June 26, 2023, 07:44:31 AM by James
Sequecing issue Started by ChrisSummers	3 Replies 31544 Views	October 18, 2019, 03:39:23 AM by ChrisSummers
Linking layups for PORT/STBD components in linking groups Started by ChrisSummers	3 Replies 25947 Views	October 08, 2019, 11:30:38 AM by Brent
Honeycomb Core Taper Analysis Started by Mike T.	3 Replies 30612 Views	July 01, 2014, 03:50:12 PM by James
Buckling margin not coinciding with FE analysis result. Started by iankim	3 Replies 32883 Views	December 21, 2012, 08:40:55 AM by Ryan
Discrete Laminates from Effective Laminates Help. Started by JEA	3 Replies 26080 Views	September 14, 2009, 07:45:08 AM by JEA
Aganin about link top/bottom facesheets of sandwich concept. Started by cmcho	4 Replies 42444 Views	July 22, 2021, 07:14:10 PM by cmcho
Correction factor for composite laminates on honeycomb core Started by HyperSizer User	4 Replies 26235 Views	June 25, 2009, 11:29:58 AM by Rocketman007
Inconsistency in Load Case Results Started by Mike T.	4 Replies 28526 Views	August 08, 2014, 08:15:23 AM by Ryan
+/-30* plies Started by eric	5 Replies 32255 Views	March 20, 2015, 09:25:45 AM by James
Hard to understand HyperSizer calculation in sandwich optimization Started by iankim	9 Replies 30378 Views	December 16, 2008, 09:01:23 AM by Phil