Creating & Editing Composite Laminates

Subject / Started by	Replies / Views	Last post
Effective Laminates and Discrete Laminates (Exporting to FEM) Started by Stressed	0 Replies 22858 Views	August 21, 2009, 10:05:26 AM by Stressed
Laminate creation form Started by ohba	1 Replies 23487 Views	March 23, 2009, 02:12:31 PM by Phil
Problem with HyperLaminates showing in Laminate Analysis Started by HyperSizer User	1 Replies 23575 Views	May 20, 2009, 03:06:52 PM by Phil
Laminate stacking sequence for sandwich panel Started by WH	1 Replies 24472 Views	January 15, 2009, 07:08:36 PM by Phil
How do you add a load case without losing component and group definitions? Started by HyperSizer Moderator	1 Replies 26784 Views	July 11, 2008, 04:44:44 PM by Phil
Laminate with different temperature properties Started by WH	4 Replies 31065 Views	February 10, 2010, 03:09:03 PM by Phil
Composite form to Creat EL (retrieved design not =Required design) Started by orchidworld	1 Replies 34326 Views	September 07, 2012, 08:32:14 AM by James
HyperSizer v6.2 importing Solid FEMs up-side-down Started by HughG	0 Replies 34720 Views	October 24, 2012, 11:58:34 AM by HughG
How to Select most of materials in the Material Clean up Dialogue Started by orchidworld	1 Replies 35133 Views	September 13, 2012, 11:15:58 AM by James
Regarding EL allowables Started by orchidworld	1 Replies 35420 Views	September 05, 2012, 12:29:02 PM by James
Composite form: Step the ply thickness is not right..... Started by orchidworld	1 Replies 35508 Views	September 07, 2012, 08:10:37 AM by James
HyperSizer v6.2 consolidating PCOMPs on import Started by HughG	2 Replies 35807 Views	October 24, 2012, 10:38:47 AM by HughG
Problem with Effective Laminate Generation with multiple fabric materials Started by HyperSizer User	1 Replies 35956 Views	March 22, 2011, 11:06:26 AM by Phil
Creat EL in the 1st step (1h), Note: assigned to the active assembly……but... Started by orchidworld	1 Replies 36013 Views	July 30, 2012, 07:02:28 PM by James
EL (Effective Laminates) Started by Stressed	2 Replies 36168 Views	February 15, 2010, 09:38:16 AM by James
Problems with sandwichpanel definition and more than one material in the faces Started by Sascha	0 Replies 36580 Views	January 22, 2015, 08:28:55 AM by Sascha
Problems Creating an Effective Laminate Started by martinjb	3 Replies 37544 Views	March 11, 2014, 09:06:37 AM by James
How do I add temperature dependent properties to a material? Started by Rocketman	1 Replies 37551 Views	June 13, 2008, 04:20:13 PM by Phil
Composite Compatibility/ Discrete laminate generation Started by cra5072	2 Replies 37634 Views	July 11, 2011, 03:08:13 PM by cra5072
Global Ply ID Definition Method? Started by khender	1 Replies 39453 Views	May 06, 2016, 05:08:07 PM by James